To Add on to a Concrete Block Wall once remodeling, you have to clean the clocks with a sponge and a pH-neutral cleanser. You need to Rinse off the cleanser with clean water. You must dry the wall with patting the moisture off with clean rags. After that, Measure the length of the wall with a tape measure. You should cut 1-by-2-inch furring strips to match the length with using a circular saw.
You can multiple strips may be required for longer walls. You have to ensure that the length of the combined strips match the wall’s length. Then, Make a mark on the wall an inch from the top and an inch from the bottom with a piece of chalk. You need to hold the end of a piece of furring strip onto the wall horizontally, so the base of the strip is at the 1-inch chalked mark. You must Tape the end of the strip in place with a piece of masking tape.
You should go to the other end of the wall and measure an inch from the floor. You can Place the strip so that the base is an inch from the floor on that end. You have to place a carpenter’s level onto the strip to ensure it’s level. You need to make any adjustments necessary to level out the strip. You must tape it into place as well.
You should walk down the length of the strip placing a chalk mark about each two feet along the top of the length of the strip to serve as a guide once mounting it to the wall. You can repeat the process for the top strip. You have to keep a gap of 1-inch from the ceiling. Next, Drill through the strips 1-inch from each end with using a hammer drill to pass through the strip and into the wall about 1-inch deep. You have to Use a vacuum with a hose to remove any concrete residue from the block after drilling.
You need to drive concrete fasteners through the strip as well as into the blocks beneath with using the electric screwdriver. You must Concrete screws are strong enough to hold the strips in position and provide the support needed for paneling. You should Place a fastener through the strip each twelve inches to secure it to the blocks. You can mount both the top as well as bottom horizontal strips to the wall. You have to stagger the fastener placement to prevent cracking the strips along a single weakened line.
Forth, Place a mark every 16-inches along the strip with the chalk to designate the location of a vertical furring strip. You need to start at the corners of the wall and work from one corner to the opposing corner with the marks. After that, Use the tape measure to measure the gap between the two horizontal furring strips. You must Cut a strip for each marked stud point on the wall with using the circular saw. Then, Attach a vertical furring strip to the wall between the horizontal strips every sixteen inches with using the same mounting process.
You should Place the first strip at one corner of the wall where it meets an adjacent wall. You can measure every 16-inch placement from the center of the preceding strip. Next, continue to place the strips until you reach the opposing wall corner. You have to attach the last vertical strip to the corner, even if it’s less than sixteen inches from the center of the preceding strip. After placement of the strips, you need to use the resultant framework to attach your remodeling products.